Enable-IT 868 Manuel d'utilisateur télécharger pdf (Page 147)

Entering Special Transducer Pipe Parameters A-1

December 2003

Appendix A

Entering Special Transducer Pipe

Parameters

If you are using special transducers, the TransPort should be

completely programmed when you receive your unit. However, in

the unlikely event that data is lost, use this appendix to properly

program pipe parameters.

The series of prompts that appear in this menu depend on the type

of special transducers you are using: wetted or clamp-on. (Refer

to the Liquid Transducer Installation Guide (916-055) for

additional information about transducers and configurations.) The

first prompt asks you to enter the transducer number. Since

special transducers do not have a number engraved on the head

(like standard transducers), you must specify it as a special and

then assign it a number between 91 and 99. Refer to Appendix D,

Menu Maps, Figure D-1D for a flow diagram of the PIPE option.

Before beginning this section, you should have entered the proper

system parameters in the SYSTeM option as described in Chapter

3, Programming Site Data.

To enter the Pipe Menu, press [F2]. The screen appears similar to

Figure A-1. The indicator box shows that you are at the beginning

of the PIPE option.

Note: If you are in RUN, press [PROG] and then [F2].

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 245 246

Pas de commentaire

Enable-IT 868 Manuel d'utilisateur Page 147