Enable-IT 868 Manuel d'utilisateur télécharger pdf (Page 65)

Programming Site Data 3-39

December 2003

Entering Setup Parameters

The SETUP option contains four sub-options that enable you to

set signal limits, response time, and decimal digits for each site,

or to initialize the setup parameters to their default values.

To enter the SETUP option, use the [←] [→] keys to scroll until

“SETUP” appears on the screen, then press [F3]. The screen

appears similar to Figure 3-9. Refer to Appendix D, Menu Maps,

Figure D-1L for a flow diagram of the SETUP option.

Figure 3-9: Screen After Pressing SETUP Key

The Setup Menu has the following four sub-options:

• SIGNaL - enables you to set the limits and other parameters

that are used to evaluate the transducer signal.

• AVeRaGe - lets you select a response time.

• DIGIT - allows you to select the digits to the right of the

decimal point for volumetric, total, power, and energy

measurements.

• INITial - lets you set all the setup parameters to their default

values.

Use the sections that follow to enter setup parameters.

SET UP

PROGRAM

SET UP

signal

SIGNL AVRG DIGIT INIT

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 245 246

Pas de commentaire

Enable-IT 868 Manuel d'utilisateur Page 65